Side by Side Cartridge Chemcial Anchor Adhesive For Thread Rods
Chemical anchor adhesive, epoxy injection mortar, Chemical fixing
Chemical anchoring system used for anchoring and rebar connections
Item #: FixingChor142
Mixing Ratio: 1:1
Side by Side Cartridge Chemcial Anchor Adhesive For Thread Rods is
a high performance, two components pure epoxy resin system. strong
fixing with exceptionally
high chemcial resistance.Applied in one single action this resin
will produce a high performance,
- High grip force, high adhesive force.
- Longer working time.
- Styrene free.
- Designed for use with threaded rod and reinforcing bar hardware
- Special application to diamond drilled holes and large bore
- The product ingredient is odorless and non-toxic.
- Orange color can be easily detected or monitored.
- Wide temperature range(5°C~+40°c)
Fixing of the following substrates:
Hard natural and reconstituted stone
Solid rock and masonry
Metal Work, carpentry
Fixing of handrails, balustrades and supports
Fixing of railings
Mechanical and electrical services installation
Anchoring of supports for ducting and equipment.
For structural work:
Bolts and special fastening systems
Rebar / steel reinforcement anchoring in new and refurbishment
Gel Performance (According to China National Standard GB50728-2011)
Splitting Tensile Strength (MPa)
Under (23±2)℃,(50±5)%RH, tested by loading speed of 2mm/min
Flexural Strength (MPa)
(no fragment damage)
Compressive Strength (MPa)
Bonding Capacity (According to China National Standard GB50728-2011)
Steel-Steel Tensile Shear Strength (MPa)
Bonding strength of Ribbed steel bar (or screw) with concrete under
constrain drawing condition
Steel-Steel T-peeling strength (mm)
Ageing resistance to heat and humidity 90d
Reduction rate of tensile strength
Under normal room temperature
(According to China National Standard JGJ145-2013)
Tensile Strength (after high temperature welding)
Dia12 Grade II steel, C30 concrete
Hole dia.16mm, Depth: 150mm
55.1N, 57.0N, 54.8N
Approved for anchorings in:
Concrete, cracked and non-cracked Applications
Rebar planting in concrete structures.
Railway or express way modification works
Curtain wall installing
Bridge modification works
Keel fixing in out wall
-If the cartridge is not finished, please clean the opening, then
put the plug back and cap tightly.
-At temperatures below 10°C should be warmed or stored in
of 10-30°C for 24hours prior to use to improve product flow and
-If the gelling time expires, please use a new static mixer.
-Do not cut or shorten nozzles.
-It can be used again in the future by replacing the static mixer.
-Please ensure hole is properly cleaned. Hole may be damp but must
be free from water.
-Do not install anchors when substrate temperature is less than
-Do not install anchors when the temperature is less than 10°C.