420ml 2:1 Two Component Chemcial Anchor Adhesive For Thread Rods
Chemical anchor adhesive, epoxy injection mortar, Chemical fixing
Chemical anchoring system used for anchoring and rebar connections
Item #: FixingChor142
Mixing Ratio: 2:1
420ml 2:1 Two Component Chemcial Anchor Adhesive For Thread Rods is
a high performance, two components pure epoxy chemcial anchor
adhesive. strong fixing with
exceptionally high chemcial resistance.Applied in one single action
this resin will produce a high performance,
- Orange color can be easily detected or monitored.
- Wide temperature range(5°C~+40°c)
- High grip force, high adhesive force.
- Longer working time.
- Styrene free.
- Designed for use with threaded rod and reinforcing bar hardware
- Special application to diamond drilled holes and large bore
- The product ingredient is odorless and non-toxic.
Suitable for medium loads and non-critical applications.
Fast working times for early loading in time sensitive
Use in extremely cold environments and fixings holes.
Good durability formulation, resistance to chemicals.
Used for studs and relatively small diameter rebar. ⋅
Fixings in concrete, wood, or other high strength materials.
Gel Performance (According to China National Standard GB50728-2011)
Splitting Tensile Strength (MPa)
Under (23±2)℃,(50±5)%RH, tested by loading speed of 2mm/min
Flexural Strength (MPa)
(no fragment damage)
Compressive Strength (MPa)
Bonding Capacity (According to China National Standard GB50728-2011)
Steel-Steel Tensile Shear Strength (MPa)
Bonding strength of Ribbed steel bar (or screw) with concrete under
constrain drawing condition
Steel-Steel T-peeling strength (mm)
Ageing resistance to heat and humidity 90d
Reduction rate of tensile strength
Under normal room temperature
(According to China National Standard JGJ145-2013)
Tensile Strength (after high temperature welding)
Dia12 Grade II steel, C30 concrete
Hole dia.16mm, Depth: 150mm
55.1N, 57.0N, 54.8N
Approved for anchorings in
Concrete, cracked and non-cracked Applications
Rebar planting in concrete structures.
Railway or express way modification works
Curtain wall installing
Bridge modification works
Keel fixing in out wall
-If the gelling time expires, please use a new static mixer.
-Do not cut or shorten nozzles.
-It can be used again in the future by replacing the static mixer.
-Please ensure hole is properly cleaned. Hole may be damp but must
be free from water.
-Do not install anchors when substrate temperature is less than
-Do not install anchors when the temperature is less than 10°C.
-If the cartridge is not finished, please clean the opening, then
put the plug back and cap tightly.
-At temperatures below 10°C should be warmed or stored in
of 10-30°C for 24hours prior to use to improve product flow and